Blind Flange, PVC, SCH 80

PVC S80 BLIND FLANGE

SEPCO ML-163 Multi-Lok, Packing, 1000 deg F, 3600 rpm Shaft, Multi-Lok Braid Acrylic

Sepco’s ML-163 packing is a multi-lok braid made of premium grade yarns, thoroughly impregnated with a special heat and chemical resistant lubricant and lightly coated with a non-contaminating film. It works very well in paper mills on Jordan pumps,...

Flange, Slip-On, 4 -Bolt Hole, Slip On, Class 150, Raised Face Shape, 316 Stainless Steel

Slip-on flanges slide over the end of piping and are then welded into place to provide sufficient strength and prevent leakage. They are ideal for lower pressure applications, and install faster and easier than other types of flanges.

SEPCO Grafoil Gasket Sheet, Graphite

Sepco’s Grafoil gaskets provide leak-free performance at moderate bolt loads, with no cold flow or creep. They eliminate precision bolt tightening and flange sticking. In fact, the prime requirement for satisfactory sealing with Grafoil gaskets is...

Thread Tape, PTFE

This PTFE tape comes in as enclosed plastic spool which has an unlimited shelf life. Since it is completely synthetic and inert, it can be used in a multitude of situations including thread sealing on pipes, sprinkler systems, plumbing lines and...

Manhole Gasket, TG, 1/4 in Thk, Texturized Fiberglass Yarns

Darco's manhole and handhole gaskets are manufactured from texturized fiberglass yarns with a brass wire, then coated with a white rubber compound. They make excellent boiler gaskets for high-temp applications.

SEPCO #ML2235 Packing, Yarn Valve, 500 deg F, 1200 fpm Shaft, 0 to 14, Multi-Lok Braid

Unlike other PTFE fluorocarbon filament packing, SEPCO® pre-lubricates the fibers of the ML2235 to provide a softer, more flexible packing with improved peripheral speed characteristics and exothermic properties. No glazing at higher speed applications,...

SEPCO #ML2225 #ML2225 Packing, Braided, 500 deg F, 1850 fpm Shaft, 3 to 11, Acrylic Fiber

The SEPCO® ML2225 are saturated and sealed with the PTFE particles, protecting the fibers from chemical action. A surface coating of PTFE is applied after braiding to assure good break-in characteristics, also a special high-temperature lubricant is...

Flange, 4 -Bolt Hole, Weld Neck, Class 150, Raised Face Shape, 316 Stainless Steel

Weldneck flanges are joined to piping systems by butt welding, and are preferred for high stresses to the pipe, reducing stress applications. The neck transmits stress concentration at the base of the flange for reinforcement.