Conveyor Screw, Helicoid, 9 in Dia, 118 in Lg, Steel, 9 in Pitch, Right Helicoid Flight, 2 in Coupling Dia

The letter “H” indicates screw conveyor with helicoid flighting. The figures to the left of the letter indicate the nominal outside diameter of the conveyor in inches. The first figure following the...

Conveyor Shaft, Drive, 21/32 in Bolt, 4-1/2 in Lg Keyway, 1/2 in Wd Keyway, 1/4 in Dp Keyway, Steel, Protective Coating, 2 in Dia Shaft, 15 in Lg Shaft, 2 -Bolt

No. 1 drive shafts are normally used where standard end plates are furnished. They are jig drilled for ease of installation.

Conveyor Shaft, Drive, Steel, Protective Coating, 3 in Dia Shaft, 23-1/2 in Lg Shaft, 2 -Bolt

Martin's Number Two drive shaft is normally used where pedestal type trough ends with single bearings are furnished. Jig drilling allows for ease of installation.

Conveyor Shaft, Steel, Protective Coating, End, 2 -Bolt, 1-1/2 to 3 in

End shafts serve to support the end conveyor section and are therefore usually supplied in cold rolled steel. End shafts are jig drilled for ease of assembly and close diametrical tolerances are held...

Conveyor Shaft, Steel, Protective Coating, End, 2 -Bolt, 2 to 3 in

End shafts serve to support the end conveyor section and are therefore usually supplied in cold rolled steel. End shafts are jig drilled for ease of assembly and close diametrical tolerances are held...

End Plate, Outside Trough, Suitable For Roller Bearing/Ball Bearing and Discharge Gate, Steel, 17-1/4 in wd, 17-3/8 in ht, 1/4 in thk

Outside trough ends with feet are used to support end bearing and cover. Drilling for ball bearings or roller bearings.

Fixed Spout, Plain Standard Discharge, Steel, Protective Coating

Standard discharge spouts are fabricated in proportion to the size and thickness of the corresponding trough. They can be furnished loose for attachment in the field or welded to the trough. The...

Fixed Spout, Plain Standard Discharge, Suitable For Discharge and Gate, 13 in Spout, 12 Bolt, 0.188 in thk Spout, 12 in dia Conveyor, Steel, 8-7/8 in wd

Standard discharge spouts are fabricated in proportion to the size and thickness of the corresponding trough. They can be furnished loose for attachment in the field or welded to the trough. The...

Flanged Gasket, Flange, Rubber, Red

Martin's TFG model flanges are used on trough ends.