Elbow, Side Outlet, Aluminium, Mill, 3.06 in lg, 3.22 in ht, Elbow, 1-1/4 in, 3.22 in Lg

Hollaender's Speed-Rail aluminum fittings make it easy to build hand rail and other pipe/fittings structures, with nothing but a saw, hex key and tape measure. The fittings are made of aluminum magnesium, and can be used with any pipe, including...

Plug, Plug, SCH 40/80, Plastic

This plastic plug fitting can be used with Schedule 40 or 80 tube only.

Coupling, Straight, Coupling, Malleable Iron, Galvanized

Designed to form an in-line joint between two pieces of tube of the same size. Where a constant diameter is required along the outside of the tube (such as for DDA handrail or garment storage), an internal spigot (type 18) should be considered.

Crossover, Clamp-On, Crossover, Malleable Iron, Galvanized

Designed to provide a 90 deg cross-over joint. Can be added to an existing structure. tube should not be joined within this fitting. For an alternative fitting, see Type 45 or Type A45.

Elbow, 90 deg Elbow, Malleable Iron, Galvanized

A 90 deg elbow joint, most frequently used as an end joint for the top rail of safety railing on a level site.

Pipe Cross, 90 deg, Galvanized Iron, Gray

Kee Klamp's #46 combination tee/crossover can be used on racking to join horizontal carrying rails to the upright, leaving the socket to take a horizontal tie across the section. For shelved racking it is usual to have the horizontal pipe outside the...

Tee, Three Socket, Tee, Galvanized, Malleable Iron

Most commonly used as the 90 deg joint between the top rail and an intermediate upright on safety railing. As there are two socket set screws in the sleeve, this fitting can be used where a join is required in the horizontal tube. The Type 10 fitting can...

Pipe Cross, Two Socket, Cross, Malleable Iron, Galvanized

Usually paired with Type 25 to give a 90 deg joint between the middle rail and an intermediate upright on safety railing. The upright passes through the fitting.

Rail Support, Malleable Iron, Galvanized

This fitting, with holes provided for countersunk flat head screw fixings only, is designed to carry handrails along walls or to fix structures back to walls. The tube passes through the fitting but does not allow for two tubes to be joined within the...