Set Screw, Kee Klam, 1/2 in Screw

Socket set screws are supplied in all Kee Klamp fittings as standard. Kee Koat™, applied as standard throughout the Kee Klamp range, provides the set screws with almost the same level of corrosion...

Single Socket Tee, 1-1/4 in, 60 deg, Iron, Galvanized, Gray , 1.72 in ID, 1.66 in OD

Kee Klamp's #29 30-60-deg single socket tees are designed as an alternative to the Type 12 fitting, this adjustable fitting is most frequently used for bracing and struts. It may be used at any...

Single Socket Tee, 90 deg, Case Hardened Steel, Iron, Galvanized, Gray

Designed to give a 90 deg butt joint between two tubes. Frequently used for the joint between end uprights and middle rail where the railing site is straight and level. Also used for base ties on...

Swivel Socket, Socket, Malleable Iron, Galvanized

A Complete combination swivel fitting, variable through 170 degs. Note: Swivel fittings are not designed to resist bending loads. A structure should not be designed entirely of swivel fittings as...

Tee, Clamp-On, 1-1/4 in, 90 deg, Case Hardened Steel, Iron, Galvanized, Gray , 1.72 in ID, 42.4 mm OD

Widely used for adding to and modifying existing structures. This performs the same function as a Type 10, but because of its open socket, it can be added to a complete structure. For an alternative...

Tee, Side Outlet, Tee, Galvanized, Malleable Iron

Most frequently paired with Type 20 to give a 90 deg corner joint for the middle rail of safety railing and other rectangular structures. The upright passes through the fitting.

Tee, Three Socket, Tee, Galvanized, Malleable Iron

Most commonly used as the 90 deg joint between the top rail and an intermediate upright on safety railing. As there are two socket set screws in the sleeve, this fitting can be used where a join is...