Tee, Clamp-On, 1-1/4 in, 90 deg, Case Hardened Steel, Iron, Galvanized, Gray , 1.72 in ID, 42.4 mm OD

Widely used for adding to and modifying existing structures. This performs the same function as a Type 10, but because of its open socket, it can be added to a complete structure. For an alternative fitting, see type A10. Type 25 should be used when a...

Single Socket Tee, 1-1/4 in, 60 deg, Iron, Galvanized, Gray , 1.72 in ID, 1.66 in OD

Kee Klamp's #29 30-60-deg single socket tees are designed as an alternative to the Type 12 fitting, this adjustable fitting is most frequently used for bracing and struts. It may be used at any selected angle between 30 deg and 60 deg. As an alternative,...

Pipe Cross, 90 deg, Galvanized Iron, Gray

Kee Klamp's #46 combination tee/crossover can be used on racking to join horizontal carrying rails to the upright, leaving the socket to take a horizontal tie across the section. For shelved racking it is usual to have the horizontal pipe outside the...

Flange, Rail, Galvanized Iron, Gray

Kee Klamp components are available in seven sizes to suit different tube diameters. The fittings are iron castings manufactured to the requirements of EN 1562 and 1563. A KEE KLAMP component (sizes 5 to 9) can support an axial load of 900 Kg per set...

Flange, Medium, Gray

Kee Klamp components are available in seven sizes to suit different tube diameters. The fittings are iron castings manufactured to the requirements of EN 1562 and 1563. A KEE KLAMP component (sizes 5 to 9) can support an axial load of 900 Kg per set...

Single Socket Tee, 90 deg, Case Hardened Steel, Iron, Galvanized, Gray

Designed to give a 90 deg butt joint between two tubes. Frequently used for the joint between end uprights and middle rail where the railing site is straight and level. Also used for base ties on racking. This fitting cannot be used where the tube...